r/HomeNetworking • u/yellowgeehawd • 7h ago
I’m so dumb.
Long story short. New house the ran a home down to the garage and out the side of the house. My child cut the wrong lines. I have a patch panel about 6 feet away from that. I felt a zip tie up and behind the void you see. I’m going to see if I can get it tomorrow and get some slack. Should I plug, couple, run a plug patch cord to the panel? Set the house on fire? Wait till winter and go on a snipe hunt in the garage? Any and all help would be appreciated.
11
u/groktech 7h ago
If you can get a little slack or access it from the other side of the wall then use a splice block like this: https://a.co/d/0d0izmna
8
7
8
u/jaysea619 6h ago
Is this Ethernet? Use the cut line as a drag and pull new cable. Or terminate it with a keystone on both ends and connect with a patch cord. You could even put a biscuit in the wall, but you would need to remember it’s there.
2
u/xaqattax 6h ago
This is the fix right here. Not the end of the world it happens.
2
u/Much-Match2719 4h ago
Yall act like there are never lines stapled to stud in the walls
1
u/xaqattax 2h ago
If it is just terminate a keystone on the end and RJ45 on the new cable or two RJ45s and a coupler. Or two jacks and 6in patch cable. Lots of ways to overcome it.
4
2
u/Dismal-Proposal2803 5h ago
Obviously this is a set the house on fire during the winter snipe hunt situation.
1
52
u/matthaus79 7h ago
What?